TABLE OF CONTENTS
Overview
A step-by-step guide to replacing the upper PCB.
Tools required
- 3 mm hex key
Replacement parts required
- Kit, Cockpit cover w/PCBA and HDWR (000-7977)
Replacement Instructions
- Unplug the bike,
Make sure the bike is unplugged at the lower stabilizer, not just from the wall. - Remove the 4 screws under the phone holder.
- Use the 3 mm hex key to remove the 4 screws pictured below:
TIP: It is difficult to remove the screws closest to the handlebars. You might need to use the short end of the hex key. - Save these screws for later.
- Use the 3 mm hex key to remove the 4 screws pictured below:
- Remove the phone holder.
- Remove the 2-wire connector by gently pulling the connector from the receiver on the board.
- Use the 3 mm hex key to remove the 2 bolts holding the phone holder in place.
- Gently slide the phone holder connector through the hole of the plastic base; set aside for later.
- Remove the 2-wire connector by gently pulling the connector from the receiver on the board.
- Remove connectors from the existing plastic base.
- Pull on the connectors to remove them from the receivers.
- Pull on the connectors to remove them from the receivers.
- Attach the existing phone holder to the new plastic base.
- Thread the connector through the new plastic base and use the existing silver screws to attach the existing phone holder to the new base.
- Thread the connector through the new plastic base and use the existing silver screws to attach the existing phone holder to the new base.
- Connect all 3 connectors to the new plastic base.
- Pay attention to the tabs on the connectors, which align with openings on the receivers.
- Pay attention to the tabs on the connectors, which align with openings on the receivers.
- Install the new assembly onto the bike.
- Use the existing black screws to connect the new phone holder assembly to the bike.
- Use the existing black screws to connect the new phone holder assembly to the bike.
- To complete the repair, follow the instructions provided by Stages Cycling support to reprogram the bike using the ATE app.