Phone Holder USB PCBA Replacement

TABLE OF CONTENTS

• Overview
  • Tools required
  • Replacement parts required
• Replacement instructions

Overview

A step-by-step guide to replacing the USB PCBA.  

• Estimated time required: 5 minutes

Tools required

• 3 mm hex key
• Flat-head screwdriver
• Pliers

Replacement parts required

• USB PCBA (000-7942)

Replacement instructions

1. Unplug the bike.
   Make sure the bike is unplugged at the lower stabilizer, not just from the wall.
   
2. Warning: Make sure the StagesBike is unplugged before doing this step
   Remove the phone shelf cover from the handlebar extrusion.
   1. Using a 3 mm hex key, remove the 3 M5 button head screws from the back of the phone shelf cover.
      
3. Remove the USB PCBA.
   1. Remove the micro USB pigtail from the retainer.
      
      
   2. Remove the PCBA.
      
   3. Unplug the connector.
      
      
4. Install new USB PCBA.
   
   1. Plug in the new USB PCBA.
   2. Place the USB PCBA in the slots located in the base.
      
   3. Route the micro USB pigtail (using a flat head screwdriver or similar tool) into the retainer on the base.
      
      
   4. Check USB port locations to make sure they are aligned with openings.
      
5. Reinstall the phone shelf cover.
   1. Install the shelf cover aligning slot with the PCB Board.
   2. Reinstall the 3 screws on the underside of the cover using a 3 mm hex key.
      
      
6. Once all the steps are complete and the repair is done, the bike can be plugged back in and used again.